Tuesday, May 28, 2013

Fixed: Toyota Highlander Brake Light

Note: This post has nothing to do with wireless. 

Toyota Highlanders are well made cars - I bought a 2004 for my wife who later upgraded to a Sienna minivan, so I took the Highlander for myself.  It's at 100,000 miles and still going strong.  However, apparently they have a known problem where the brake lights on one side will intermittently stop working.  I've had people pull up next to me at stop lights and tell me I have a light out, then I get home to find the light is fine.

Then recently the light went out and stayed out.  I replaced the bulbs but they remained out.  Fuses were fine, my trusty Fluke 77 said voltage was getting to the assembly.  Posters in Toyota forums said that dealers are asking $40 - $140 for diagnostic, plus possibly $300 to replace a "circuit board"...?  Sounds like a scam to me.

I did some searching online and found reference to how the contacts on the bulb holder will get compressed and not make proper contact. (Kudos to Berto for the original post and Kujath for the photos.)  Kujath suggested using a flat-blade screwdriver to bend the contacts a bit, but I think a needle-nose pliers works better since you can control the amount of bending.  I did both bulb holders and the lights are working just fine. 

2 comments:

Unknown said...

As long as they will not a recall after! I think that would be great! Toyota is indeed a father of evolution for car!

Unknown said...

David thanks for this post. I tried this and it still didn't work on the vehicle. SOLUTION: clean all of the contact points! I used rubbing alcohol with a Qtip and that solved the problem!

I cleaned the tabs on ALL the lights and there was visible corrosion on the main light line, the one with the gray socket.

Thanks for this post; you helped me save A LOT of money!!!